Roll of joint adhesive for interior and exterior use. Solvent-free, permanent, elastic, frost-resistant airtight adhesive that is applied from a roll, for bonding all types of vapour retarders and vapour barriers
Length: 10m
Solvent-free, permanent, elastic, frost-resistant airtight adhesive that is applied from a roll, for bonding all types of vapour retarders and vapour barriers – e.g. pro clima INTELLO, DB+, INTESANA, DASATOP and DA, as well as PE, PA, PP or aluminium sheeting – on mineral or rough adjacent components such as masonry, plasterwork, concrete or roughly sawn wood in accordance with DIN 4108-7, SIA 180 and OENORM B 8110-2.
Sticking of windtight joints on commercially available underlay and sarking membranes (e.g. those made of PE and PET). Joint adhesion in combination with the pro clima SOLITEX MENTO family of products, SOLITEX UD, SOLITEX PLUS and SOLITEX UM fulfils the requirements of the ZVDH product data sheets.
Windtight sticking of wall-lining membranes of all types (e.g. pro clima SOLITEX FRONTA WA, SOLITEX FRONTA QUATTRO or SOLITEX FRONTA PENTA).
| Material | |
| Material | SOLID acrylate |
| Release film | Silicone-coated PP film |
| Attribute | Norm | Value |
| Colour | translucent green | |
| Width of adhesive bead | 11 mm ; 7/16" | |
| Thickness of adhesive bead | 3 mm ; 1/8" | |
| Moisture resistance | waterproof | |
| Adhesion | EN 1939 | 16 N/cm |
| Application temperature | from -15 °C; 5 °F | |
| Temperature resistance | permanent -40 °C to 100 °C ; -40 °F to 212 °F | |
| Storage | horizontal, cool and dry, protect from direct sunlight |
Before sticking, subsurfaces should be brushed off, wiped clean with a cloth or cleaned using compressed air. Mineral surfaces (plaster or concrete) may be slightly moist.
Bonding to frozen surfaces is not possible. There must be no water-repellent substances (e.g. grease or silicone) on materials to be bonded. Subsurfaces must have sufficient load-bearing capacity - if necessary, a mechanical support (pressure lath) must be used (e.g. on crumbling subsurfaces).
Permanent adhesion is achieved on all pro clima interior and exterior membranes, other vapour retarder and airtight membranes (e.g. those made of PE, PA, PP and aluminium) as well as other underlay/sarking and wall lining membranes (e.g. those made of PP and PET).
Bonds can be created on mineral subsurfaces (e.g. plaster or concrete), roughly sawn, planed and painted wood, hard plastics and rustproof metal (e.g. pipes, windows etc.) and hard wood-based panels (chipboard, OSB, plywood, MDF panels).
The best results in terms of structural stability are achieved on high-quality subsurfaces.
It is your responsibility to check the suitability of the subsurface; adhesion tests are recommended in certain cases.
Pretreatment with TESCON PRIMER RP is recommended in the case of subsurfaces with insufficient load-bearing capacity.
The bonds must not be subjected to tensile forces. It may be advisable to use mechanical reinforcements.
Rub the bond firmly into place (e.g. using the pro clima PRESSFIX application tool).
The product achieves its final level of strength after approx. 24 h.
